User Guide

Spanning Tree Commands
7-83
7
Spanning Tree Commands
The commands described in this section are used to set the MAC address table
aging time and spanning tree parameters for both the Ethernet and wireless
interfaces.
bridge stp enable
This command enables the Spanning Tree Protocol. Use the no form to disable the
Spanning Tree Protocol.
Syntax
bridge stp enable
no bridge stp enable
Default Setting
Enabled
Command Mode
Global Configuration
Example
This example globally enables the Spanning Tree Protocol.
Table 7-15. Bridge Commands
Command Function Mode Page
bridge stp enable Enables the Spanning Tree feature GC 7-84
bridge stp forwarding-delay Configures the spanning tree bridge forward time GC 7-85
bridge stp hello-time Configures the spanning tree bridge hello time GC 7-85
bridge stp max-age Configures the spanning tree bridge maximum age GC 7-86
bridge stp priority Configures the spanning tree bridge priority GC 7-86
bridge-link path-cost Configures the spanning tree path cost of a port IC 7-87
bridge-link port-priority Configures the spanning tree priority of a port IC 7-87
show bridge stp Displays the global spanning tree settings Exec 7-88
show bridge link Displays current bridge settings for specified interfaces Exec 7-82
Enterprise AP(config)bridge stp enable
Enterprise AP(config)