User Guide

Command Line Interface
7-88
7
Ethernet Interface Commands
The commands described in this section configure connection parameters for the
Ethernet port and wireless interface.
interface ethernet
This command enters Ethernet interface configuration mode.
Default Setting
None
Command Mode
Global Configuration
Example
To specify the 10/100Base-TX network interface, enter the following command:
Table 7-16. Ethernet Interface Commands
Command Function Mode Page
interface ethernet Enters Ethernet interface configuration mode GC 7-89
dns primary- server Specifies the primary name server IC-E 7-90
dns secondary- server Specifies the secondary name server IC-E 7-90
ip address Sets the IP address for the Ethernet interface IC-E 7-90
ip dhcp Submits a DHCP request for an IP address IC-E 7-91
speed-duplex Configures speed and duplex operation on the
Ethernet interface
IC-E 7-92
shutdown Disables the Ethernet interface IC-E 7-93
show interface ethernet Shows the status for the Ethernet interface Exec 7-93
Enterprise AP(config)#interface ethernet
Enterprise AP(if-ethernet)#