User Guide

Installation Procedures

3-3

To connect pigtail cables to the access point, follow these steps:

1. Disable the access point radio using the web browser interface, CLI, or SNMP.

2. Remove power to the access point.

3. Remove both of the access point’s antennas by unscrewing them at their base.

4. For diversity antennas, connect the antenna pigtail cables to the exposed

Reverse SMA connectors on both sides of the access point.

For non-diversity antennas, be sure to connect the single pigtail cable to the

Reverse SMA connector on the access point’s side activated through the

software interface.

Unscrew

antenna to

remove

Antenna pigtail

cable

Screw onto access point’s

Reverse SMA connector