User's Manual

`
IP CAM User’s Guide
P
P
a
a
n
n
/
/
T
T
i
i
l
l
t
t
I
I
P
P
S
S
u
u
r
r
v
v
e
e
i
i
l
l
l
l
a
a
n
n
c
c
e
e
C
C
a
a
m
m
e
e
r
r
a
a
IP CAM USER’S GUIDE PAGE 9/57 Rev. PV1.0
B. Check if the IP addresses for PC network and CAM_EZ Search are on the
same network section:
l Usually, static IP address will be used to access into Internet, so the IP
address will vary. When you want to change IP address, please write
down the original IP address on your computer first. Then you have to
modify the IP address of your computer for testing if the IP-CAM can be
operated normally or not. After finishing the test, IP address for your
computer should be recovered to original settings.
l In general, the IP address for your computer in LAN will be set with “Auto
Obtain IP address”. To test if the IP-CAM is normal or not, the IP
address of your computer must be changed temporarily. After finishing
the test, it can be recovered to original settings.
C. Next, choose Control Panel->Network Connections->choose the activated area
Network Connections---> right click your mouse --->select Properties(P)--->
Select Internet Protocol (TCP/IP)---> Select Properties(R) , then you can check
the current IP address status for the computer. The way to modify IP address is:
D. Open and execute CAM_EZ Search (as shown in Figure 2). The system will scan
the IP-CAM that you just installed automatically. Then, you will find 255IP CAM in
the column of Camera Lists. Click 255IP CAM with left mouse button. You can see
the default settings for IP-CAM.
IP Address(I):192.168.9.5
Subnet Mask (U):255.255.255.0
Default Gateway(D):192.168.9.254