User's Manual

Appendix D: Using the Key Pad
Page 145 | August 17, 2010
Sending an Emergency Police Alarm
Press and hold this button for about 2 seconds to send a silent alarm to central monitoring for
police assistance. This Disarm works the same as though you performed this operation from the
TouchScreen.
The button flashes red to indicate that the alarm has been sent. The TouchScreen will not react in any way but if
you check the History tab on the Security widget, you are able to see that an alarm was sent. Additionally, Contact
persons will receive email and SMS notifications if they are configured to do so.
Mounting the Key Pad
To mount a key pad to the wall:
1. Use a Phillips screwdriver to remove the faceplate from the front
of the key pad (Figure 53).
Behind the circuit board, four holes are visible at the back of the device.
Figure 53
2. Place the key pad on the wall where you want it located and use a pen to mark the location of the
four holes.
3. Install four screws in the locations marked on the wall. Do not screw them in all the way.
4. Affix the key pad to the installed screws.
5. Replace the faceplate to the front of the key pad.