User's Manual

Appendix E: Using the Key Fob
Page 149 | August 17, 2010
Sending an Emergency Police Alarm
Press and hold the
button for 2.25 seconds to send a silent alarm to central monitoring for
police assistance. The LED flashes orange to indicate that the alarm has been sent. The TouchScreen
will not react in any way, but if you check the History tab on the Security widget, you are able to see
that an alarm was sent. Additionally, Contact persons will receive email and SMS notifications if they
are configured to do so.
Changing the Batteries in the Key Fob
To replace the batteries in the key pad:
1. Holding the key fob in one hand, carefully insert the tip of a flat-
head screwdriver into the casing seam.
2. Push lightly and twist the screwdriver handle.
3. Find the supplied CR2032 3-volt lithium battery.
4. Remove the circuit board and rubber button pad from the key
fob casing.
5. Insert the battery in the battery slot positive side away from the
circuit board.
6. Replace the circuit board in the key fob casing.