- SMC Actuators Operating Manual

39
[Procedure]
1) Remove the pulley case cover using two Allen wrenches, one of 2 mm across flats and the other of
3 mm across flats.
2) Move the rod to a position where Z phase turns on (home position).
This corresponds to a position where the rod projects 2 mm from the mechanical end.
Apply countermarks in this position.
Warning: If the actuator is installed vertically, move it after turning on the controller power
and forcibly releasing the brake. At this time, beware of danger as the actuator
may drop suddenly.
Always provide a support to brace the actuator hand to prevent sudden drop, so
as not to pinch fingers or damage the load.
M3 hexagon socket
head screws
M4 hexagon socket
head screws
Cause the rod to project 2 mm from the mechanical end.
Apply countermarks once the rod has projected
2 mm from the mechanical end.
2 mm