Manual

3.6.2.3. System Log

Fig. 53.System log settings.

System events can be logged to the on-board RAM of the SMC2582W-B (Local log) or sent in the

form of SNMP trap (Remote log by SNMP trap) or BSD Syslog (Remote log by BSD Syslog) to

a remote SNMP trap monitoring server or remote Syslog server,respectively.See the next subsection

for more information about SNMP trap settings.Set the IP address of the Syslog server in the Syslog

server IP address text box.

The system events are divided into the following categories:

• General: system and network connectivity status changes.

• Built-in AP: wireless client association and WEP authentication status changes.

• MIB II traps: Cold Start,Warm Start,Link Up,Link Down and SNMP Authentication Failure.

NOTE: The SNMP Authentication Failure trap is issued when using an incorrect community

string to manage the SMC2582W-B via SNMP and the SNMP MIB II OID, snmp Enable

AuthenTraps,is enabled (disabled by default).

3.6.2.4. SNMP

Fig. 54.SNMP settings.

The SNMP (Simple Network Management Protocol) functionality can be disabled,and you can spec-

ify the name (used as a password) of the read-only and read-write community.In addition,up to 5

SNMP trap targets can be set in the SNMP Trap Table.