Owner manual

1. Open your web browser
(i.e. Internet Explorer or
Netscape Navigator).
2. In the “Location” field
(for Netscape) or “Address” field
(for Internet Explorer), type
“http://192.168.123.254”
and press <ENTER>.
3. In the ”System Status” page
of the Barricade web console,
type your password in the
“System Password” field
(default is “admin”) and click
the “Log In” button.
4. Click “Primary Setup”
5. Make sure “WAN Type”
is set to “Dynamic IP
Address” and enter the
host name given to you by
your ISP (i.e. CX123456).
Troubleshooting
Here are some things to try if, after following the steps in this
guide, you still have problems with:
Connecting to the Internet
How do I find out which WAN type to select?
Use the following general rules to determine which
WAN type your ISP uses:
A. If your ISP has given you a
specific “IP Address”, select
“Static IP.”
B. If use a Username and a
Password to log in to your
service, select “PPP over
Ethernet.”
C. If you use an external dial-up
modem connected to your
Barricade, select “Dial-up Network.”
D. If your ISP has given you a
“host-name”, select “Dynamic
IP Address.”
I can’t access the Internet through my Barricade.
Depending on your Internet Service Provider (ISP), there are
settings that you must change in order to connect to the Internet.
A. If you subscribe to an
“@Home”
service and have a dynamic IP
address, you will need to enter
a “host name.” If your ISP
does not require a host name,
you must leave this field blank.
To enter your host name:
English
English