User's Manual

– 20 –

3 INSTALLATION GUIDE

The sections that follow describe the hardware and software installation

procedures and some additional configuration required to connect your

SMCWTVA100 into your existing LAN or WLAN. The following sections are

included:

◆ How to Connect the TV Adapter

◆ Install Screencasting Software

◆ Connect a Device to the SMCWTVA100

◆ Non-Bridged Connection Setups

HOW TO CONNECT THE TV ADAPTER

For a basic “stand-alone” hardware install of the TV adapter, perform the

following steps:

OTE

If Internet is required for your display function, before installing the

TV adapter, make sure your PC, smartphone or tablet-PC is successfully

connected to the Internet through a broadband service. If there are any

problems, first contact your ISP to resolve them.

1. Plug in the power cord.

2. Connect the HDMI cable to the HDMI output of the SMCWTVA100 and

to the HDMI input of your TV, projector or monitor.

3. To turn on the SMCWTVA100, push in the power button until it clicks in

the depressed position.

4. Follow the on-screen instructions to set up the SMCWTVA100. The

system default mode is PC to TV mode, which means it is ready to

display any media from your PC including presentations, video, music,

and photos.

5. You can switch between five modes by pushing the mode button on the

side of the unit (next to the USB port) two or three times. The on-

screen instructions will prompt you to push the button again after the

first or second push.