User's Manual

HAPTER

| Installation Guide

Connect a Device to the SMCWTVA100

– 24 –

OTE

Using an Ethernet cable can increase your device’s Internet speed as

compared to the “Bridge to Wireless” mode..

■

To use your SMCWTVA100 without an Internet connection (no

bridge, see Figure 7 on page 24), select “Virtual AP only” (default

setting). Click Apply and no further steps are necessary.

You are now ready to use the SMCWTVA100 in the Virtual AP

(stand-alone) configuration. Go to “Operation Modes” on page 45

for procedures on how to screencast.

Figure 7: Stand-Alone Connection Setup

7. (Note: Bridge to Wireless only as shown in Figure 8)

Click the “Scan AP” button and click to select the 802.11 wireless

access point that you would like to bridge the internet from.

The SMCWTVA100 will restart and connect to the wireless AP that you

selected, giving you both screencast and Internet connectivity. No

further steps are necessary you are now ready to use the

SMCWTVA100 in the Bridge to Wireless configuration. Go to “Operation

Modes” on page 45 for procedures on how to screencast.