User's Manual

C HAPTER 3 | Installation Guide
Connect a Device to the SMCWTVA100
– 25 –
Figure 8: Bridge to Wireless Connection Setup
N OTE : The device will receive a new IP address from the wireless AP that it
connects to. Use that new IP address to log into the device from your web
browser. The new address and URL will be shown on the initial screen that
is output from the HDMI connection to a display device.
8. (Note: Bridge to Ethernet only, as shown in Figure 9)
Connect an RJ-45 Ethernet cable from the device’s RJ-45 port to a
suitable Internet connection and then click Apply in the Quick Settings
menu with Bridge To Ethernet selected in the drop-down menu.
The SMCWTVA100 will reboot to receive a new IP address over the
wired internet connection. No further steps are necessary you are now
ready to use the SMCWTVA100 in the Bridge to Ethernet configuration.
Go to “Operation Modes” on page 45 for procedures on how to
screencast.