User manual

C LASS OF S ERVICE C ONFIGURATION
3-177
Click Priority, IP Port Priority. Enter the port number for a network
application in the IP Port Number box and the new CoS value in the Class
of Service box, and then click Apply.
Figure 3-78 IP Port Priority
CLI – The following example globally enables IP Port Priority service on
the switch, maps HTTP traffic (on port 1) to CoS value 0, and then
displays the IP Port Priority settings.
Note: Mapping specific values for IP Port Priority is implemented as an
interface configuration command, but any changes will apply to
the all interfaces on the switch.
Console(config)#map ip port 4-262
Console(config)#interface ethernet 1/1 4-168
Console(config-if)#map ip port 80 cos 0 4-263
Console(config-if)#end
Console#show map ip port ethernet 1/5 4-268
TCP port mapping status:enabled
Port Port no. COS
--------- -------- ---
Eth 1/ 1 80 0
Console#