User manual

C ONFIGURING THE S WITCH
3-178
Mapping CoS Values to ACLs
Use the ACL CoS Mapping page to set the output queue for packets
matching an ACL rule as shown in the following table. Note that the
specified CoS value is only used to map the matching packet to an output
queue; it is not written to the packet itself. For information on mapping
the CoS values to output queues, see page 3-166.
Command Usage
You must configure an ACL mask before you can map CoS values to the
rule.
Command Attributes
• Port – Port identifier.
• Name
13
– Name of ACL.
• Type – Type of ACL (IP or MAC).
• CoS Priority – CoS value used for packets matching an IP ACL rule.
(Range: 0-7)
Table 3-13 Egress Queue Priority Mapping
Priority 01234567
Queue 12034567
13. For information on configuring ACLs, see page 3-60.