User manual

C LASS OF S ERVICE C ONFIGURATION
3-179
Web – Click Priority, ACL CoS Priority. Enable mapping for any port,
select an ACL from the scroll-down list, then click Apply.
Figure 3-79 ACL CoS Priority
CLI – This example assigns a CoS value of zero to packets matching rules
within the specified ACL on port 12.
Changing Priorities Based on ACL Rules
You can change traffic priorities for frames matching the defined ACL
rule. (This feature is commonly referred to as ACL packet marking.) This
switch can change the IEEE 802.1p priority, IP Precedence, or DSCP
Priority of IP frames; or change the IEEE 802.1p priority of Layer 2
frames.
Console(config)#interface ethernet 1/12 4-168
Console(config-if)#map access-list ip bill cos 0 4-130
Console(config-if)#