User manual

E NTERING C OMMANDS
4-11
For example, you can use the following commands to enter interface
configuration mode, and then return to Privileged Exec mode.
Command Line Processing
Commands are not case sensitive. You can abbreviate commands and
parameters as long as they contain enough letters to differentiate them
from any other currently available commands or parameters. You can use
the Tab key to complete partial commands, or enter a partial command
followed by the “?” character to display a list of possible matches. You can
also use the following editing keystrokes for command-line processing:
VLAN vlan database Console(config-vlan) 4-231
MSTP spanning-tree
mst-configuration
Console(config-mstp)# 4-214
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#
Table 4-3 Keystroke Commands
Keystroke Function
Ctrl-A Shifts cursor to start of command line.
Ctrl-B Shifts cursor to the left one character.
Ctrl-C Terminates the current task and displays the
command prompt.
Ctrl-E Shifts cursor to end of command line.
Ctrl-F Shifts cursor to the right one character.
Ctrl-K Deletes all characters from the cursor to the end of
the line.
Ctrl-L Repeats current command line on a new line.
Ctrl-P Enters the last command.
Table 4-2 Configuration Commands (Continued)
Mode Command Prompt Page