User manual

C OMMAND G ROUPS
4-13
SNMP Activates authentication failure traps; configures
community access strings, and trap managers; also
configures IP address filtering
4-149
Interface Configures the connection parameters for all
Ethernet ports, aggregated links, and VLANs
4-167
Mirror Port Mirrors data to another port for analysis without
affecting the data passing through or the
performance of the monitored port
4-182
Rate Limiting Controls the maximum rate for traffic transmitted
or received on a port
4-184
Link Aggregation Statically groups multiple ports into a single logical
trunk; configures Link Aggregation Control
Protocol for port trunks
4-186
Address Table Configures the address table for filtering specified
addresses, displays current entries, clears the table,
or sets the aging time
4-200
Spanning Tree Configures Spanning Tree settings for the switch 4-205
VLANs Configures VLAN settings, and defines port
membership for VLAN groups; also enables or
configures private VLANs and protocol VLANs
4-231
GVRP and
Bridge Extension
Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for the
bridge extension MIB
4-249
Priority Sets port priority for untagged frames, selects strict
priority or weighted round robin, relative weight
for each priority queue, also sets priority for TCP
traffic types, IP precedence, and DSCP
4-254
Multicast Filtering Configures IGMP multicast filtering, query
parameters, and specifies ports attached to a
multicast router
4-271
IP Interface Configures IP address for the switch 4-282
Table 4-4 Command Group Index (Continued)
Command Group Description Page