User manual

C OMMAND L INE I NTERFACE
4-282
IP Interface Commands
An IP addresses may be used for management access to the switch over
your network. The IP address for this switch is obtained via DHCP by
default. You can manually configure a specific IP address, or direct the
device to obtain an address from a BOOTP or DHCP server when it is
powered on. You may also need to a establish a default gateway between
this device and management stations or other devices that exist on another
network segment.
Basic IP Configuration
Table 4-69 IP Interface Commands
Command Function Mode Page
ip address Sets the IP address for the current
interface
IC 4-283
ip dhcp restart Submits a BOOTP or DCHP client
request
PE 4-284
ip default-gateway Defines the default gateway through
which this switch can reach other
subnetworks
GC 4-284
show ip interface Displays the IP settings for this device PE 4-285
show ip redirects Displays the default gateway configured
for this device
PE 4-286
ping Sends ICMP echo request packets to
another node on the network
NE,
PE
4-287