User's Manual

4-3
Fiber Optic SFP Devices
4
Figure 4-2 Network Wiring Connections
Fiber Optic SFP Devices
An optional Gigabit SFP transceiver (1000BASE-SX, 1000BASE-LX or
1000BASE-ZX) can be used for a backbone connection between switches, or for
connecting to a high-speed server.
Each single-mode fiber port requires 9/125 micron single-mode fiber optic cable with
an LC connector at both ends. Each multimode fiber optic port requires 50/125 or
62.5/125 micron multimode fiber optic cabling with an LC connector at both ends.
Warning: These switches use lasers to transmit signals over fiber optic cable. The lasers
are compliant with the requirements of a Class 1 Laser Product and are
inherently eye safe in normal operation. However, you should never look
directly at a transmit port when it is powered on.
Note: When selecting a fiber SFP device, considering safety, please make sure that it
can function at a temperature that is not less than the recommended maximum
operational temperature of the product. You must also use an approved Laser
Class 1 SFP transceiver.
Advertencia: Estos conmutadores utilizan láseres para transmitir señales a través de un
cable de fibra óptica. Los láseres satisfacen los requisitos de un producto
láser Clase 1 y son intrínsecamente seguros para los ojos en operación
normal. Sin embargo, nunca deberá mirar directamente a un puerto de
transmisión cuando está energizado.
Equipment Rack
(side view)
Network Switch
Patch Panel
Punch-Down Block
Wall
wititch10/1 00
6724L3
E
S
4
5
2
4
C