AUTOMATIC BUILT-IN COFFEE MACHINE EN INSTRUCTION MANUAL
A15 A16 A21 A A24 A22 A17 A2 A3 A5 A23 A7 A8 A6 A11 A19 A9 A1 A13 A18 A10 A4 A12 A14 2 A20
B B2 B3 B4 B5 B6 EN B7 00:00 B1 AROMA B11 PROFILE 1 SELECT BEVERAGE QUANTITY B8 B10 B9 ESPRESSO COFFEE CAPPUCCINO LATTE MACCHIATO C3 C C6 C4 C1 C2 C5 C7 D2 D D5 D1 D4 D7 D3 D6 3
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 4
EN 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 5
31 32 33 34 35 36 37 38 39 40 41 42 44 45 B A B A 43 6
CONTENTS MAKING MILK-BASED HOT DRINKS......................................15 Filling and attaching the milk container.......................15 Adjusting the amount of froth......................................16 Making milk based hot drinks automatically................16 Cleaning the milk container after use...........................16 INTRODUCTION......................................................................8 Symbols used in these instructions.................................
INTRODUCTION Symbol used in these Instructions Important warnings are identified by these symbols. Failure to observe the Instructions for Use could result in electric shock, serious injury, burns, fire or damage to the appliance • Danger! Failure to observe the warning may result in life threatening injury by electric shock. • Important! Failure to observe the warning could result in injury or damage to the appliance. Danger of burns! Failure to observe the warning could result in scalds or burns.
• • • • • or other liquids. To reduce the risk of injury, do not drape cord over the counter top or table top where it can be pulled on by children or tripped over unintentionally. Do not let the cord hang over the edge of a table or counter, or touch hot surfaces. Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions or has been damaged in any manner. Return appliance to an authorized service faciliy for examination, repair or adjustement.
A5. Infuser A6. Lighting to illuminate interior compartment A7. On/stand-by button / knob (only on some models) A8. Control panel A9. Tray for objects A10. Hot water/steam connection nozzle D2 D3. D4. D5. D6. D7. A11. Lighting knob to illuminate the interior compartment (only on some models) A12. Water tank A13. Coffee spouts (adjustable height) A14. Drip tray A15. Beans container lid A16. Beans container A17. Grinding adjustment dial A18. Lights to illuminate cup A19. Main ON/OFF switch A20.
• • • On first use the water circuit is empty, the machine could therefore be very noisy: the noise will lessen as the circuit fills up. When making the first 5-6 cappuccinos, it is normal to hear the noise of boiling water: after this the noise will lessen. To improve the performance of the appliance, we recommend installing a water softener filter (C4) as described in section “Water softener filter”.
appears on the display (B); 3. Press : The values for the first beverage appear on the display; 4. The reference user profile is highlighted on the display. The values are shown on the vertical bars: the manufacturer de- 2. Press (B10) or (B8) until the display (B) shows AUTO-START; 3. Select the function by pressing : The time setting panel appears on the screen; 4. Press or corresponding to the hours and minutes until the required auto-start time is displayed; 5.
2. Press (B10) or (B8) until ENERGY SAVING appears on the display (B); 3. Press to enableor disableenergy saving. 4. Press to go back to the homepage. 2. Press (B10) or (B8) until the display (B) shows LIGHT; 3. Press to enableor disablethe cup lighting; 4. Press to go back to the homepage. Coffee temperature Please note: The lighting to illuminate the interior compartment A6 comes on when the appliance is turned on.
(fig. 13): this helps achieve a better cream; 4. Press (B10) or (B8) until the required coffee is displayed; 5. Then select your required coffee from the homepage: • ESPRESSO • DOPPIO+ • COFFEE • LONG • 2 X ESPRESSO • AMERICANO 6. Preparation begins and the display (B) shows the image of the selected beverage together with a progress bar which gradually fills as preparation proceeds.
For fuller bodied creamier coffee, turn one click anticlockwise towards 1 (do not turn more than one click at a time otherwise the coffee could come out one drop a drop at a time). Please note: If you use pre-ground coffee, you can only make one cup of coffee at a time. 1. Repeat Press AROMA (B6) until the display (B) shows (pre-ground). 2. Open the cover (A15) and the pre-ground door (A23). 3. Make sure the funnel (A21) is not blocked, then add one level measure of pre-ground coffee (fig. 14). 4.
nozzle (A10) (fig.19): the machine will let out a noise signal (if the sound notification function is enabled); 5. Place a sufficiently large cup under the coffee spouts (A13) and frothed milk spout (D5); adjust the length of the milk spout, to move it nearer to the cup, simply pulling it downwards (fig. 20). 5. Follow the instructions below for each function. • At the end of delivery, to increase the quantity of coffee in the cup, press .
1. Make sure the hot water/steam spout (C6) is attached correctly to the hot water/steam connection nozzle (A10); 2. Place a container under the spout (as close as possible to avoid splashes); • • 3. Select HOT WATER from the homepage. The corresponding image appears on the display (B), together with a progress bar which fills gradually as preparation proceeds; 4. The machine delivers hot water, then delivery stops automatically. To interrupt hot water delivery manually, press .
pending on the previous selection): press The appliance goes back to the homepage. • • • Cleaning the appliance internal circuit . If the appliance is not used for more than 3/4 days, before using it again, we strongly recommend switching it on and: 1. performing 2/3 rinse cycles by selecting the "Rinse" function (paragraph “Rinsing "; 2. delivering hot water for a few seconds (section “Delivering hot water”).
Cleaning the inside of the coffee machine Important! Do not use washing up liquid to clean the infuser to avoid removing the lubricant applied to the inside of the piston. Danger! Before cleaning internal parts, the machine must be turned off (see section “Turning the appliance off”) and unplugged from the mains power supply. Never immerse the coffee machine in water. 1. Check regularly (about once a month) that the inside of the appliance (accessible after removing the drip tray - A14) is not dirty. 2.
Cleaning the hot water/steam connection nozzle ing solution. The display shows DESCALING PLEASE WAIT : the de-scale programme starts and the de-scaler liquid comes out of the hot water/steam and coffee spouts. A series of rinses and pauses is automatically carried out to remove all the scale residues from the inside of the coffee machine; After about 25 minutes, de-scaling stops: 9. RINSE AND FILL WATER TANK UP TO MAX LEVEL (fig. 41): the appliance is now ready for a fresh water rinsing cycle.
• ly eliminated from the machine's internal circuits. Before starting rinsing, remember to empty the drip tray; The appliance may request de-scaling cycles at very short intervals. This is normal and due to the appliance’s advanced control system through an authorised customer service centre. To use the filter correctly, follow the instructions below. Installing the filter 1. Remove the filter (C4) from the packaging; 2. Press PROGRAMMING WATER HARDNESS (B2) to enter the menu; 3.
point 4. To postpone replacing the filter to another time, press : on the display the symbol is a reminder that the filter needs to be replaced. To replace, proceed as follows: 1. Extract the water tank (A12) and exhausted filter; 2. Remove the new filter from the packaging; Voltage: 120 V~ 60 Hz max. Absorbed power: 1350W Pressure: 15 bar Water tank capacity: 84.5 fl. oz / 2.5 litres Size:LxHxD: 3.5 x 17.7 x 18.5 in / 597x450x470 mm 3. Press Net weight: 44 lb / 20 kg (B2) to enter the menu; 4.
DISPLAYED MESSAGES EN DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY FILL WATER TANK WITH FRESH WATER Water in the tank (A12) is not sufficient. Fill the tank with water and/or insert it correctly, pushing it as far as it will go until it clicks into place. EMPTY GROUND CONTAINER The grounds container (A4) is full. Empty the grounds container and drip tray (A14), clean and then replace them.
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY ADD PRE-GROUND COFFEE PRE-GROUND MAXIMUM ONE MEASURING CUP A LONG coffee with pre-ground coffee Place pre-ground coffee in the funnel (A21) (fig. 14) has been requested and press to continue and complete delivery. FILL BEAN CONTAINER The coffee beans have run out. GROUND TOO FINE. ADJUST GRIND LEVEL 1 CLICK WHILE IN OPERATION The grinding is too fine and the coffee is Repeat coffee delivery and turn the grinding adjustment dial (fig.
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY INSERT WATER OUTLET The hot water spout (C6) is not inserted or is inserted incorrectly Insert the water spout as far as it will go. INSERT MILK CONTAINER The milk container (D) is not inserted correctly. Insert the milk container as far as it will go (fig. 19). INSERT BREWING UNIT After cleaning the infuser has not been Insert the infuser as described in par. "Cleaning the replaced. infuser".
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY PRESS OK TO START CLEANING PROCESS OR TURN MILK FROTH ADJUSTMENT KNOB The milk container has been inserted To proceed with the CLEAN function, press with the froth adjustment dial (D1) in the or turn the froth adjustment dial to one of the milk CLEAN position . positions. TURN THE MILK FROTH ADJUST- Milk has been delivered recently and the MENT KNOB TO START CLEANING tubes inside the milk container must be cleaned (D).
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY GENERAL ALARM: REFER TO USER MANUAL The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as described in section “Cleaning”. If the message is still displayed after cleaning, contact an authorised Customer Service centre. Reminder that appliance needs de-scaling The de-scaling procedure described in section “Deand/or the filter (C4) must be replaced.
TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Customer Services Technical Assistance. PROBLEM POSSIBLE CAUSE REMEDY The coffee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot water (Please note! the hot water function can be used).
PROBLEM POSSIBLE CAUSE REMEDY The milk does not come out of the The lid (D2) of the milk container (D) Clean the milk container lid as described in par. milk spout (D5) is dirty "Cleaning the milk container". The milk contains large bubbles and The milk is not cold enough or is not Use fully skimmed or semi-skimmed milk at squirts out of the milk spout (D5) or semi-skimmed or skimmed. refrigerator temperature (about 5° C).
ESPRESSO Origin PROCESS Italy Grinding Coffee powder 6-11gr (according to aroma) Brewing Pre-infusion • Infusion high pressure (9-12 bar) RESULT IN CUP Default Quantity ~ 40ml Cream compact and nut-coloured Taste intense OCCASION OF USE short-term pleasure, every moment of the day COFFEE Origin PROCESS Germany & Central Europe Grinding Coffee powder 8-14gr (according to aroma) Brewing Pre-infusion no pre infusion Infusion high pressure (9-12 bar) RESULT IN CUP Default Quanti
CAPPUCCINO Origin PROCESS RESULT IN CUP OCCASION OF USE CAPPUCCINO+ Origin PROCESS RESULT IN CUP OCCASION OF USE CAPPUCCINOMIX Origin PROCESS RESULT IN CUP OCCASION OF USE LATTE MACCHIATO Origin PROCESS RESULT IN CUP OCCASION OF USE FLAT WHITE Origin PROCESS RESULT IN CUP OCCASION OF USE CAFFELATTE Origin PROCESS RESULT IN CUP OCCASION OF USE Italy Coffee balanced (~ 80ml) Milk balanced (~ 70ml) Milk foam maximum level Delivery order milk first, coffee afterwards Visual separate
FIG. 1 FIG. 2 23.3-23.5 in x 28 x2 17.7-17.9 in 0.07 in (=) in -0.8 0.7 17.7 in 17.7 1.2 in FIG. 2A 0.07 in in x1 1.7 in approx 1.7 in 17.7 + 0.07 in 1.7 in x1 1.7 in 1.7 in 1.7 in .6 in in. 19 n .4 in M 19.6 i .4 in Min. 21 21 33.4 in Min .3 in 33.4 in Min .3 in 22 + 0 17.7 + 0.07 in 1.7 in 23.3-23.5 in 17.7-17.9 in 17.7-17.9 in 21.4 in (=) 23.3-23.5 in 16.8 in 16.8 in 21.4 in 22 + 0 x1 x2 1.7 in 2 . 13.
x2 FIG. 3 x1 FIG. 5 x1 x1 x4 x1 x4 . 13.7 approx in 22 + 0.03 in 22 + 0.03 in . 13.7 in approx FIG. 4 FIG. 6 x2 x4 4 560 + 1 mm FIG.
The manufacturer reserves the right to make any changes deemed useful for improvement of its products without prior notice. The illustrations and descriptions contained in this manual are therefore not binding and are merely indicative.
SMEG S.p.A. Via Leonardo Da Vinci, 4 42016 San Girolamo di Guastalla (RE) ITALY www.smeg.