Contents 1.1 1.2 1.3 1.4 1.5 1.6 Introduction This user manual Intended use Manufacturer liability Identification plate Disposal 2 Description 2.1 Product description 2.2 Description of parts 2.3 Standard accessories 3 Use 3.1 3.2 3.3 3.4 3.5 7 7 7 8 8 8 9 9 10 11 13 Before first use Using the stand mixer Using the pouring shield Functions Speed setting suggestions 4 Cleaning and Care 4.1 4.2 4.3 4.4 7 EN 1 Instructions Instructions Maintenance Ordinary daily cleaning What to do if...
Important Safeguards RECOGNIZE SAFETY INFORMATION This is a safety alert symbol. This symbol alerts you to potential hazards that can result in severe personal injury or death. UNDERSTAND SIGNAL WORDS A signal word - DANGER, WARNING or CAUTION - is used with the safety alert symbol. DANGER denotes the most serious hazards. It means you could be killed or seriously injured if you do not immediately follow the instructions.
WARNING To reduce the risk of fire, electrical shock, personal injury, or damage when using the appliance, follow basic safety precautions, including the following: Follow all safety instructions in order to use the appliance safely. • Read this user manual carefully before using the appliance. • To protect against electric shock, do not immerse the appliance, the power cord or the plug in water or any other liquid.
Important Safeguards For this appliance • Turn the appliance OFF, then unplug from the outlet when not in use, before assembling or disassembling parts and before cleaning. To unplug, grasp the plug and pull from the outlet. Never pull from the power cord. Permanently Installed - Make sure appliance is OFF when not in use, before putting on or taking off parts, and before cleaning. • Unplug the appliance from the power socket as soon as you have finished using it and before cleaning it.
1 Instructions 1.1 Introduction Key information for the user: Instructions General information on this user manual, on safety and final disposal. Description Description of the appliance and its accessories. Use Information on the use of the appliance and its accessories, advice on preparing recipes with the appliance. Cleaning and care Information for correct cleaning and care of the appliance. Safety instructions Information Advice 1.
Important Safeguards 1.6 Disposal Warning • This product contains a chemical known by the State of California to cause cancer, birth defects or other reproductive harm. • This appliance can cause low-level exposure to some of the substances listed, including benzene, formaldehyde, carbon monoxide, toluene, and soot. 1.
Description EN 2 Description 2.1 Product description 1 7 3 11 6 12 3 5 4 10 4 13 2 14 9 8 Model SMF02 - SMF03 - SMF13 - Stand Mixer 1 Motor head 2 Body 3 Power and speed selector 4 Head raising/lowering release button 5 Lower attachment shaft for supplied attachments 6 Front attachment hub for optional accessories 7 Front hub cover 8 Bowl base 9 Bowl** 10 Splash-proof pouring shield* 11 Dough hook 12 Flat beater 13 Wire whisk 14 Flex edges beater* *Standard only on certain models.
Description 2.2 Description of parts Motor head (1) Upper part of the appliance, rotates the attachments and accessories. Power and speed selector (3) Lever for speed selection. The ‘0’ position of the lever corresponds to the OFF position (appliance off). To start the appliance, position the lever on one of the 10 available speeds (positions 1-10), depending on the type of mixing required. See “3.5 Speed setting suggestions” for more details and suggestions.
Description EN 2.3 Standard accessories Aluminum dough hook Stainless steel wire whisk For slowly combining, mixing and kneading leavened dough type mixtures including bread, pasta, pizza, etc. For beating, mixing, whisking and whipping ingredients such as butter, eggs, cream, etc. Aluminum flat beater Also ideal for preparing creams, custards, sauces, etc. Flex edges beater* For combining, mixing, and starting all mixing procedures. For preparing cake batters and pastries, biscuits, icing, etc.
Use Pouring shield* For protecting against splattering and to make it easier to add ingredients while mixing. Suitable only for use with the stainless steel bowl*. The attachments and accessories intended to come into contact with food are made of materials that comply with the provisions of current legislation. *Standard only on certain models. Only available as an optional accessory.
3 Use Electrical Shock Hazard • • • • • Plug into a grounded 3-prong outlet. Do not remove the ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Volts: 120 Volts AC only. Hertz: 60 Hz Your stand mixer has a 3-prong grounded plug. To reduce the risk of electrical shock, this plug will fit into an outlet only one way. If the plug does not fit in the outlet, contact a qualified electrician.
Use 3.2 Using the stand mixer 1. Place the mixer on a flat, stable and dry surface. 2. Press the release button (1). 3. Hold down the button and raise the head (2), accompanying its movement with your hand. 4. Insert the bowl (3) in its base (4). Grasp the bowl by its handle (5) and turn the bowl (3) clockwise until it locks into place. 2 A 1 4 3 B 5 There may be a slight movement of the motor head while kneading or mixing heavy ingredients or those in large quantities.
6. Slip the attachment (6) onto the lower attachment shaft (7) and push it upwards. Keep pressing the attachment upwards and turn it counterclockwise until the pin (8) locks fully into place. 7. Add the ingredients to the bowl. 8. To close, bring the motor head down by pressing the release button (1), and then tilt the motor head (2) backwards slightly until it releases. 9. Keep the button pressed down and lower the head (2), accompanying its movement with your hand. 2 7 6 1 8 10.
Use 11. Check that the speed selector (10) is positioned on ‘0’ (OFF). 12. Insert the plug into the power socket. 13. Select the required speed (from 1 to 10) using the selector (10) to start the appliance and begin mixing the ingredients. See “3.5 Speed setting suggestions”. 10 Warning! • For greater safety, each time that power is cut to the motor, for example by raising the motor head or unplugging the appliance, the speed selector must be returned to zero in order to restart the mixer.
When you have finished using the mixer: 1. Position the speed selector (10) on ‘0’ (OFF) and unplug the mixer from the socket. 2. Remove the pouring shield, if it is on the bowl (9). 3. Press the release button (1) to raise the head (2).
Use 4. Push the attachment (6) upwards slightly and turn it clockwise to unlock it from the pin (8). Remove the attachment (6) from the lower attachment shaft (7). 5. Remove the bowl (3) from its base (4) by turning it counterclockwise to release it.
3.3 Using the pouring shield 1. Before placing the splash-proof shield (1) on the upper edge of the stainless steel bowl*, secure the bowl in the base, secure the utensil on the lower attachment and lower the head into the operating position. 2. Fit the pouring shield with the opening (1) facing outwards in order to add ingredients to the bowl without stopping the mixer.
Use 3.4 Functions Planetary movement Safety lock system The planetary movement is generated by rotation (1) of the attachment around its axis in the opposite direction to the rotary movement (2) of the mixer. This movement maximizes coverage of the entire bowl with consistent results for all mixtures. The appliance has a safety system which automatically shuts off the appliance when the motor head is raised.
Use EN 3.5 Speed setting suggestions The speed selector shows the most appropriate attachment to use with the selected speed. The speeds indicated in the table are approximate and can vary depending on the recipe and the interaction of the different ingredients used. Speed setting LOW 1-3 LOW 1-3 MEDIUM 4-7 HIGH 8 - 10 Function Accessory COMBINE Combining ingredients. KNEAD Kneading - preparing leavened dough (bread, pizza, pastries, egg pasta), see “ Dough for bread, pizza and egg pasta”.
Use Table of recommended attachments, suggested speeds and maximum capacities Attachment Preparation Speed Time Min/max capacity Egg whites 8 -10 2-3 min 2-12 (1) Cream 8-10 2-3 min 100 ml/1000 ml (3.4 oz/ 34 oz) Pre-prepared cake batters 1-7 3-4 min 2 kg (4 lb 7 oz) total batter Batters for desserts 1-7 3-4 min 2.6 kg (5 lbs 12 oz) total batter Bread/pizza dough 1-3 4 min 1.8 kg (4 lbs) total dough (max 1.
General recommendations Tips for whipping egg whites • Never exceed the maximum speeds and capacities indicated in the table to avoid damaging the appliance. • Start the appliance at a low speed until the ingredients are mixed in, then increase the speed according to the operation to be carried out. • When adding ingredients, always pour them from the edge of the bowl and not directly on the attachment while it is in motion.
Use Tips for working with eggs Pre-prepared cake batters • For best results, use eggs at room temperature. • When preparing dry mixtures, do not use more than 3 medium-sized eggs and add small quantities of water if necessary. • For batters up to 1 kg (2 lb 3 oz): start the appliance at low speed until the ingredients begin to blend, then gradually increase the speed to 7 for the remaining time.
Cleaning and Care 4.1 Instructions Improper use Danger of electrocution • Switch off and unplug the appliance before cleaning the mixer and its attachments and accessories. Improper use Risk of damage to surfaces • Do not use steam jets to clean the appliance. • Do not use cleaning products containing chlorine, ammonia or bleach on steel parts or parts with metallic finishes (e.g. anodized, nickel- or chrome-plated). • Do not use abrasive or corrosive detergents (e.g.
Cleaning and Care 4.4 What to do if... Problem Possible cause The motor has overheated. Solution Disconnect the mixer from the power and leave the motor to cool. Insert the plug into the power socket. Do not use The plug is not properly inserted in adaptors or extensions. the power socket. Check that the breaker is on. The motor will not start The cable is defective. Have the cable replaced at an Authorized Service Center. Lack of power. Check that the house main breaker is on.
Problem Possible cause EN Cleaning and Care Solution The mixer is not resting on a stable Place the mixer on a flat, surface. stable surface. The anti-slip rubber feet are worn. Have them replaced at an Authorized Service Center. The mixer vibrates The speed used is too high or the Set a lower speed and ensure the bowl has not load is excessive. been overfilled. Check that the bowl is The bowl has not been correctly correctly locked into its locked into its base. base.
Cleaning and Care Problem The attachment is struggling to turn inside the bowl Possible cause The dough mixture is too thick and Add water or other liquid to is stopping the attachment from loosen the dough mixture. turning. The bowl is too full. If the problem has not been resolved or in the event of another type of fault, contact your local technical support center. 28 Solution Remove half the bowl’s contents and work it separately.