Instructions / Assembly

Pre-Installation
IMPORTANT: Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have occurred
during shipping. If there is a defect in the wire, do not
attempt installation. Please call the Customer Service
Team at 1-800-388-6141 ext. 216. For customer service
support and the fastest response, please email us at
[e-mail].
NOTE: Hardware not shown to actual size.
NOTE: The LED has been permanently installed in this
lamp. The LED does not need to be replaced. Do not
attempt to remove or replace the LED. Do not touch the
LED or electrical connection directly with hands.
PLANNING INSTALLATION
Read all instructions before installing.
To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard.
Phillips
Screwdriver
Safety
Goggles
Wire
Stripper
Electrical
Tape
Pliers
TOOLS REQUIRED (NOT INCLUDED)
HARDWARE INCLUDED
AA
CCBB
EE FF
DD
3
Part Description Quantity
AA
Mounting strip
1
BB
Outlet box screw (short)
2
CC
Green ground screw
(Pre-assembled to the mounting strip (AA))
1
DD
Support screw (long)
2
EE
Wire connector
3
FF
Hex nut
2