Use and Care Manual

MAINTENANCE

CHAIN MAINTENANCE

Use only a low-kickback chain on this saw. This fast-cutting chain provides kickback

reduction when properly maintained. For smooth and fast cutting, maintain the chain

properly. The chain requires sharpening when the wood chips are small and powdery, the chain

must be forced through the wood during cutting, or the chain cuts to one side.During maintenance

of the chain, consider the following:

• Improper ling angle of the side plate can increase the risk of severe kickback

• Raker (depth gauge) clearance.

• Too low increases the potential for kickback.

• Not low enough decreases cutting ability.

• If the cutter teeth hit hard objects such as nails or stones, or are abraded by mud or sand on

the wood, have an authorized service center sharpen the chain.

1/32 in. (0.6 mm)

Raker (Depth Gauge) Clearance

NOTE:

• Inspect the drive sprocket for wear or damage when replacing the chain. If signs of wear or

damage are present in the areas indicated, have the drive sprocket replaced by an authorized

service center.

• If you do not fully understand the correct procedure for sharpening the chain after reading

the instructions that follow, have the saw chain sharpened by an authorized service center or

replace with a recommended low-kickback chain.

Not for Reproduction