Safety Instruction & Operators Manual for SNAPPER MODEL 2100 HHB HAND HELD BLOWERS p Thank you for buying a Snapper Product! Before operating your blower, read this manual carefully and pay particular attention to the Important Safety instructions on page two. Remember that blowers and all power equipment can be dangerous if used improperly and keep in mind that satiety requires careful use In accordance with the instructions and ..common sense! OVERSIMPLIFICATION AR COOLED, TWO CYCLE DISPLACEMENT..
A\ IMPORTANT SAFETY INSTRUCTIONS A WARNING: Falter to comply with the following instructions may result in serious injury to the operator or other persons. The owner of the blower must understand these Instructions and, furthermore, must allow only persons who understand these instructions to operate the unit. Each person operating the blower must be of sound mind and body and must not be under the influence of any substance which might Impair vision, dexterity, or judge£ men.
OPERATING INSTRUCTIONS ' PER-MIX FUEL (32 to 1 RATIO) For proper lubrication, the engine must operate on an exact mixture of gasoline and 2 cycle air-cooled engine oil. Use mixture. Use a good quality regular grade laded or unleaded gasoline and SNAPPER special formulated 2-cycle engine oil. Do not use the special 50:1 ratio oils. The 8210 1 ratio equals 4 ounces of oil to each gallon {U.S. Standard) of gasoline, gallons gasoline. Refer to the following chart for correct mixtures. iy 32:1 RATIO .U.
OPERATING INSTRUCTIONS (continued) Make aura each person you authorize to operate your blower carefully reads and understands the important safety instructions on page 2 of this manual and PULL CHOKE rainbows how to stop the unit quickly in preparation for LEVER possible emergency situations. To stop, press and K BACK TORN hold the red STOP SWITCH (Figure 2) down until the engine comes to a complete halt, ’ PER-START PROCEDURE Perform the following services before each start-up.
OPERATING INSTRUCTIONS (continued) BLOWER OPERATION Remember to wear eye and/or face protection to prevent injury from objects ricocheting into eyes and face. Also wear a dust mask when working under dusty conditions, Use the flared nozzle to sweep weeds areas or the jet nozzle to direct the air blast in a more precise area. Maintain firm footing and balance at all times do not operate while attempting to climb ladders or on steep slopes or roofs.
SERVICE: PROCEDURE {continued) ALTER ELEMENT REMOVE AIR FILTER COVER . SCREW 5" RETAINED BY FILTER COVER FILTER SERVICE . SPARK PLUG SERVICE The spark plug on a 2-cycle engine will quickly become oll saturated i the engine is run at low speed for any length of time. The spark ply electrodes also tend to become carbon fouled. Check the plug frequently especially if hard starting is experienced. The spark plug is located Inside the opening at the front center housing of the unit.
SERVICE PROCEDURE (continued) ‘CARBURETOR ADJUSTMENTS: Do not tamper with carburetor settings. if the engine will not start, stalls at idle, or stalls under rapid acceleration and the cause is not due to clogged air cleaner, fuel filter, bad muffler or fouled spark plug, readjust the carburetor as follows with engine stopped. 1. Tum the L needle to the right until it bottoms lightly do not force closed. Then turn it to the left one (1) furn, .
SHOULDER STRAP/™ 1 MANUFACTURER’S 2 YEAR LIMITED WARRANTY oy For two (2) Years from purchase date for the purchaser's residential, non-commercial use [ninety (30} days from purchase date for the original purchaser's commercial, rental, or other nonresidential use], and for 3 years on the ignition module, SNAPPER POWER EQUIPMENT, through any SNAPPER dealer will replace, free of charge, any part or parts found upon examination by the factory at McNaughton, Georgia, to be defective in material or workmanship o