Manual

PRE-OPERATION CHECKLIST for SNAPPER
SINGLE STAGE SNOW THROWERS
Complete each of the following items prior to placing the machine into service. It is very important that setup is
verified and all operational tests completed and results are acceptable. Check ( _ ) all items actually performed.
After completing this form, sign and retain for future reference.
SET-UP
__ UPPER HANDLE & LOWER HANDLE secured in place and hardware tightened securely.
DISCHARGE CHUTE and DEFLECTOR ASSEMBLY installed on snow thrower.
CLEAN-OUT TOOL attached to handle on snow thrower.
LUBRICATION
__ ENGINE OIL added to bring level up to full mark on 4-cycle engines (Refer to Engine Manual).
__ OIL mixed with FUEL in specified ratio (2 Cycle Engines Only). (Refer to Engine Manual).
OPERATIONAL TEST
__ AUGER checked to insure stopping within 5 seconds after clutch control is released.
__ ENGINE started, engine control settings checked and adjusted as needed.
FUEL SYSTEM checked for leaks around tank and connections.
DISCHARGE CHUTE checked for free rotation.
__ AUGER CONTROL CABLE adjusted per instructions in the Operator's Manual supplied with machine.
CONSUMER INFORMATION
Purchase Date
Retailers Name
Address
MACHINE WILL BE USED COMMERCIALLY?
Purchaser's Name
Address
Model Serial No.
City State Zip
YES NO
Signature
City State Zip
IMPORTANT: This form is to be retained for future reference regarding Warranty, proof of purchase, traceability
for product recall or service, etc. Complete the Snapper Product Registration Card and Mail to Customer
Service Department at SNAPPER, P.O. BOX 1379, McDonough, Georgia, 30253.
INSTRUCTION No. 7100948 (I.R. 6/26/2006)
TP 300-5206-00-SX-SN