Instructions / Assembly

Self-Contained Ice Maker User Manual for Installation and Maintenance
7
Instruction of Control Panel
1. LED Display:
 Self-check： Display “ini” code.
 Preparing： Counting seconds positively.
 Ice making: Counting seconds positively
prior the water reaching 0 degree C.
Counting seconds down to 0 s after.
 Ice Harvest: Counting seconds positively.
 Clean: Display “CLE” during cleaning and
sterilizing;Display “rin” during rinsing.
2. LED Lamps: Lights on during the related
process.
3. Ice cube thickness adjustment: During the
ice making process, if you are not satisfied
with the ice thickness, press the Ice cube
“–” button for 3 seconds, then click the
button “+” or “-” on the panel to adjust the
thickness of ice cube.
 


4. Cleaning: During the normal operation,
hold the cleaning button for 3 seconds to
enter the cleaning process. During the
entire cleaning process, cleaning agents
and disinfectants need to be put into the
water trough. When the clean process is
finished, the ice maker will go to ice
making process.
5. Switch: When the device is powered, click
the “Switch” button to switch OFF/ON the
device.
6. Voice function (only for machines with
voice function): The machine with voice
announcement prompts will provide voice
prompts for related operations.
7. Please open and close the storage bin
door gently. Do not slam the door. After
taken the ice cubes, please close the door.
8. If the ice maker is not in use for a long time,
it should be energized and run for 2 to 4
hours every 2 months.

 If the ice machine has not detected ice
cube falling off in three cycles, it will shut
down for safety protection. The ice maker
needs to be checked.
 The ice machine detects that the ambient
temperature is too high and will stop for
safety protection.
 If the water-cooled ice machine detects an
abnormity in water supply, it will stop for
safety protection.
 The fault code and its comments are
displayed as follows:
Code
Comments
Machine action
E01
Sliding board fails
Protective shutdown
E03
Overtime of ice
making
Protective shutdown
E04
High temperature
Protective shutdown
E05
Water shortage
Protective shutdown
E06
High pressure
Protective shutdown
E07
Condensation
sensor open
circuit
Not stop
Error LED light on
every 5s
E08
Condensation
sensor short
circuit
Not stop
Error LED light on
every 5s