Use and Care Manual

9
30SB, 36SB, 45SB
Rev Nov2014
Snow BEAST
Assembly Instrucons
Step 1: Control Panel Handles
1. Align the two holes on each side of the control panel
handles over the lower handle frame.
2. Insert the bolts through the handlebar holes and frame
holes. Secure in place with hardware provided. Insert
bolts from the inside.
Step 3: Chute Rotaon Cable
Aach the cable coming from the middle of the
control panel by screwing the cable end onto the
crank secon.
See next page for specic instrucons regarding
this assembly.
Need Help With Assembly?
1-919-550-3221
Step 2: Direconal Discharge Chute
1. Fit the black plasc round spacer onto impeller
housing before installing chute. Apply light coat of
grease onto spacer.
2. Install the bolts for the retainer brackets with the
plasc spacer between the chute and the steel
retaining tabs.
DO NOT OVERTIGHTEN. If the bracket is too ght the
chute will not move properly. Ensure there is enough
space between the impeller housing and the bracket on all
sides so that the chute rotates smoothly.