Use and Care Manual

10
30SB, 36SB, 45SB
Rev Nov2014
Snow BEAST
1. Locate the connecon: The chute rotaon cable connecon is located at
the base of the discharge chute between the engine and the discharge chute.
2. Slide the threaded end of the connector down
the cable in order to easily see the end of the cable
connecon. The center secon should be about
3/4” to 1” beyond the end of the cable.
NOTE: There is nothing wrong if the end of the cen-
ter secon of the cable protrudes more than about
3/4” to 1” beyond the end of the cable.
The center secon can be easily pushed back into
the cable.
3. Align the center secon with the cable chute rotator. The end
of the center secon is square and requires proper alignment in
order to correctly connect to the machine.
4. Press the cable toward the chute rotator screw. The end of
the cable should touch the end of the chute rotator.
If the surfaces do not contact, connue to apply pressure and
slowly rotate the discharge chute direcon handle on the control
panel so the center of the cable aligns itself on both ends.
5. Slide the threaded end from Step 2 toward the chute rotator,
and thread the end onto the chute rotator.
IMPORTANT: Finger ghten rmly. Inspect before each use to make certain
the connecon doesn’t loosen during operaon of the machine.
Step 3: Chute Rotaon Cable (connued)
Assembly Instrucons
Need Help With Assembly?
(919)-550-3221