Use and Care Manual

11
30SB, 36SB, 45SB
Rev Nov2014
Snow BEAST
Step 4: Chute Direcon Control Cable Support
With the rubber lined strap removed, put the
chute direcon control cable and the chute
deector cable into the opening, and press the
strap together aligning the hole for the bolt.
Secure strap to side of the engine.
NOTE: Rotate discharge chute and ensure there is
no binding of any cables and there is enough slack
in the deector cable for full rotaon.
Need Help With Assembly?
(919)-550-3221
Step 5: Dri Cuers (if desired)
1. The dri cuers are aached to the main hous-
ing in the stored posion.
2. Remove the two bolts on each dri cuer.
3. Reaach the dri cuers in the operang posi-
on.
4. Replace bolts and secure ghtly.
Step 6: Skid Shoes
1. Skid shoes are stored in the hardware bag for shipping.
2. Remove from hardware bag, and install skid shoes using the
provided fasteners
3. Insert the fasteners so the at head of the carriage bolt is
toward the inside of the main housing.
CAUTION: Check the skids to ensure that the auger does not
contact the paved or gravel surface. Adjust skids as necessary to
make up for wear on the snow blower.
Posion skid shoes so that the scraper blade is elevated at least
1/4” from the ground. This allows easier maneuvering and
prevents drag on the snow blower when encountering unseen
imperfecons on the surface to be cleaned.
1. Check the re pressure to ensure the res are properly
inated.
2. Move skid shoes up and down to the desired posion based
on the surface texture.
 If the surface is rougher adjust the skid shoes lower which
increases the auger ground clearance.
 If the surfaces is smoother adjust the skid shoes higher
(decrease ground clearance). Firmly ghten the nuts that
secure both skids to the auger sides.