Use and Care Manual

30SB, 36SB, 45SB

Rev Nov2014

Snow BEAST

High Mark

Step 10: Filling Oil and Gasoline

1. Fill the engine with SAE 5W-30 engine oil. Fill the engine with 1.2 to 1.5 quarts of oil. Fill up to the full level mark

on the dip sck. Do not overll.

When checking oil, remove dipsck, wipe completely clean, insert dipsck into dipsck tube on the engine (do

NOT screw dipsck down), remove dipsck and observe oil level (detail below).

Keep oil level at the high run mark for longest engine life.

2. Check that the fuel inlet screen is clean and ll the tank to the proper level leaving adequate space for fuel to

DANGER: GASOLINE IS HIGHLY FLAMMABLE AND

EXPLOSIVE. Do not add fuel while the engine is

running or is hot. Keep open ames, sparks, and heat

away from the fuel and store fuel in containers

specically designed for that purpose. ADD FUEL

OUTDOORS ONLY. IF THE FUEL IS SPILLED, DO NOT

START THE ENGINE. Manually push the snow blower

away from the spill and wipe up immediately.

DANGER

Step 9: Headlight

1. Connect snow blower headlight wire plug to the

headlight bulb.

2. Connect the headlight bezel to the control panel.

A. Tilt headlight assembly and align tabs on the

top of the headlight bezel with the notches in

the control panel. Insert the notches into the

panel.

B. Tilt headlight assembly down while gently

squeezing the headlight bezel and push

Assembly Instrucons

Need Help With Assembly?

(919)-550-3221

GASOLINE IS HIGHLY FLAMMABLE AND

EXPLOSIVE. FUEL LEAKS, A LOOSE FUEL TANK,

OR A LOOSE FUEL VALVE CAN LEAD TO

SEVERE INJURY OR DEATH. DO NOT OPERATE

THIS SNOW BLOWER IF ANY COMPONENT OF

THE FUEL SYSTEM IS LOOSE OR LEAKS

GASOLINE!

Check engine oil level before each use. Maintain

oil level between run marks on the dipsck, and

change oil according to the maintenance

schedule to maximize product life.

Low Mark