Use and Care Manual

15
30SB, 36SB, 45SB
Rev Nov2014
Snow BEAST
Operang Instrucons
Transmission Control
Your snow blower is equipped with an easily
adjustable transmission control, which can be
adjusted for forward and reverse speed.
There are six forward and two reverse speeds.
To change the speed, pull the handle out to the right
and move the handle to the desired speed.
IMPORTANT! The snow blower belts are adjusted to ensure the augers stop turning within ve (5) seconds of
releasing the impeller control lever. If you are making any belt adjustments whatsoever, for your safety and the
safety of others around you, you must ensure the belts are re-adjusted to achieve this design specicaon.
To Stop Engine
To stop the engine, pull the safety key up unl the engine
and augers/impeller stops running. For safety, it is
recommended that you remove the key when not using
the snow blower.
WARNING
WARNING! Do not operate the snow blow-
er with defecve guards, shields, or without
the safety devices securely in place.
Engage Transmission Drive
To engage the transmission drive squeeze the right lever to
the hand grip.
To disengage, let go of the right lever.
Engage Augers/Impeller Control
To engage the augers/impeller drive, squeeze the le
lever to the handgrip.
To disengage release the le lever.
DO NOT shi speeds while
the transmission is engaged.
Come to a complete stop
and disengage the transmis-
sion handle before changing
speed or switching from
forward to reverse.
WARNING