Use and Care Manual

22
30SB, 36SB, 45SB
Rev Nov2014
Snow BEAST
Service Adjustments
Adjusng Drive Cable
If tension seems to be too loose or too ght, the
drive
cables needs to be readjusted.
1. Loosen the bolt above where the cable screws
in
to the right side of the control panel.
2. Loosening the bolt en-
ables the cable to
screw in
further, which makes
the augers/impeller
handle ghter.
3. Adjust the bolt and
cable to the necessary
adjustments.
Adjusng Augers/Impeller Cable
If tension seems to be too loose or too ght, the
augers/impeller, cables needs to be readjusted.
1. Loosen the bolt above where the cable screws
in
to the le side of the control panel.
2. Loosening the bolt en-
ables the cable to
screw in further, which
makes the augers/
impeller handle ght-
er.
3. Adjust the bolt and
cable to the necessary
adjustments.
Adjusng Shi Rod
The shi rod will be at a preset posion from
the factory, but aer use, or maintenance, the
shi rod may require occasional adjustment.
Signs of adjustment need:
1. The shi handle is moved to the F1 posion,
and when the engagement handle is
pressed, the unit does not move.
2. The shi handle is moved to the R1 posion,
and when the engagement handle is
pressed, the unit does not move.
If either of the above occur, it may be necessary
to adjust using the following procedure:
1. Set the transmission handle to the space
between F1 and R1 as shown on the right.
2. Loosen the 2 nuts on the adjustment
turnbuckle.
3. Remove the cover plate from the transmission
housing
4. Adjust the rod by turning the turnbuckle unl
the fricon wheel aligns with the center of the