Use and Care Manual

23
30SB, 36SB, 45SB
Rev Nov2014
Snow BEAST
Vercal Service Posion
For some procedures it is necessary to put the snow blower into the vercal service posion as instructed
below. This allows for easy access to the top and the boom of the snow blower.
1. Remove or place the dri cuers into the stored posion.
2. Push up on the handle bars and rock the snow blower forward onto the front face of the collector housing
as shown below.
Service Adjustments
Cauon! Unit is heavy, this may require the
assistance of a second person.
 Remove all fuel from fuel tank if possible by:
- Turn fuel valve o
- Remove fuel hose from fuel valve
- Install short piece of fuel hose to valve
- Turn fuel valve on and drain into gasoline safe
container
 Make certain fuel valve is o.
 Tighten fuel and oil caps
 Remove key
 Close fuel valve
DANGER: GASOLINE IS HIGHLY FLAMMABLE AND
EXPLOSIVE. Do not add fuel while the engine is
running or is hot. Keep open ames, sparks, and heat
away from the fuel and store fuel in containers
specically designed for that purpose. ADD FUEL
OUTDOORS ONLY. IF THE FUEL IS SPILLED, DO NOT
START THE ENGINE. Manually push the snow blower
away from the spill and wipe up immediately.
DANGER