Use and Care Manual
24
30SB, 36SB, 45SB
Rev Nov2014
Snow BEAST
Inspecon & Replacement of the
Transmission Belt
The transmission belt is located under the belt guard
between the engine and impeller. Follow the
procedure below to inspect or replace the belt.
Remove key, remove spark plug cable from spark plug
and ground to the engine.
1. Loosen the two fasteners on either side of the belt
cover. The cover will li up and away from the
snow blower during removal.
The fasteners require a 10mm wrench or socket/
ratchet.
2. Pull the transmission tension pulley arm away
from the belt.
While pulling the tension pulley arm, push the belt
toward the engine—o of the pulley and onto the
cranksha.
3. Remove the impeller belts from the front of the
engine pulley. These belt should ONLY be
removed from the engine pulley.
Follow procedure for replacement of impeller belts
for this item.
4. Put snow blower into the vercal service posion
standing on the front of the collector housing as
instructed on page 23.
5. Remove the boom cover (6 bolts) with a 10mm
wrench or socket/ratchet.
6. Remove the transmission belt from the aluminum
pulley toward the back of the snow blower.
7. Pull the belt from the top side of the snow blower.
The belt will have to be turned to the at side to
move between the fricon wheel and the
aluminum drive disk.
The belt will removed between the impeller pulley
on the engine and the impeller belts removed in
Step 3.
8. Reroute the new belt in reverse order from the
Service Adjustments
Bolts
Bolts