Use and Care Manual

26
30SB, 36SB, 45SB
Rev Nov2014
Snow BEAST
Adjusng Discharge Deector
The discharge chute is preset at the factory, but
may require adjustment over me or during
maintenance.
For adjustments, follow the procedure below:
1. Loosen the two nuts at the chute cable mount
on the discharge chute.
2. To make the chute open more, adjust nuts so
the cable end moves closer to the discharge
deector (upward).
3. To make the chute close more, adjust nuts so
the cable end moves further from the
Service Adjustments
Changing Fricon Wheel
If the fricon wheel needs to be replaced for any
reason:
1. Remove the six bolts to remove the cover
underneath the control panel between the
wheels.
2. Remove the bolt and nut in the hexagonal
sha carrying the fricon wheel
3. With the bolt and locking nut removed, the
sha can be removed with the rubber fricon
wheel assembly.
4. Replace the fricon wheel and reassemble in
reverse order.
5. Reseng the neutral posion may be
necessary.
The fricon wheel can also be removed from the
vercal service posion as outlined on page 23. It
can be removed without liing the unit into the
vercal service posion.
Replacing Headlight Bulb
1. Push the headlight case up from the
boom, then gently li the headlight out.
2. Twist and remove bulb from headlight
assembly
3. Replace the bulb and lock the headlight back
into place the same way it was taken out.
Replacement bulbs are available for purchase
through GXI Parts & Service.