Use and Care Manual

Owner’s Manual
13 | Page
SnowBear
®
Tailgate Spreader (TGS-325)
Revision 2
General Maintenance
The SnowBear
®
Tailgate Spreader is generally maintenance free, but there are a few recommendations to
help ensure many seasons of trouble-free operation.
WARNING: Never remove the spreader with material in the hopper. Always empty before removing.
CAUTION:
 Disconnect electric power at spreader electrical harness plug connection before servicing or
performing maintenance.
 When replacing parts, use only original manufacturer's parts. Failure to do so will void warranty.
 Remote receiver is a solid-state electronic unit and is not serviceable. Any attempt to service will
void warranty.
 There are no serviceable parts in the motor assembly. Any attempt to service will void warranty.
 If pressure washing spreader motor/electrical enclosure area, stay at least 48" [1.2m] away and
avoid direct spray on the openings to avoid excessive water intrusion.
 During removal or mounting, securely grip spreader to avoid dropping.
AFTER EACH USE
 Do not leave unused material in the hopper. Material can freeze or solidify, causing unit to not work
properly. Empty and clean after each use.
 Wash out hopper & rinse off all external surfaces, especially spinner and deflector areas.
 Apply dielectric grease on 4-pin connector plugs to prevent corrosion.
AT THE END OF EACH SEASON OR AFTER EXTENDED STORAGE
 Wash out hopper & rinse off all external surfaces.
 Apply dielectric grease on 4-pin connector plugs to prevent corrosion.
 Paint any bare, non-stainless steel, metal surfaces to prevent corrosion.
STORAGE
 Store the spreader in a clean, dry location and preferably away from direct sunlight.