Assembly Instruction

3of5
STEP 1 Drill Pilot Holes on Post-
A. Carefully fit the Post Fitter over the end of the Post (not
supplied), making sure the Post Fitter is fully seated.
B. Mark the drill point for the (3) Mounting Screws, using
(3) Mounting Holes as reference. After marking hole
locations, remove fixture from post and drill 1/16” pilot
holes for screws.
Post
Figure 1
Post Fitter
Figure 2
STEP 2 Make Wire Connections-
A. Use standard wire connectors to make all wire
connections. (Connectors are not included with fixture.)
Strip and prepare wire ends according to instructions
supplied with connectors.
B. Connect White Supply Wire from the Post to White Wire
from fixture.
C. Connect Black (or Red) Supply Wire from the Post to
Black Wire from fixture.
D. Connect Ground Wire from the Post to Ground Wire from
fixture.
E. Twist connectors until wires are tightly joined together.
F. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Post.
Figure 3
White wire from supply White wire from fixture
Black wire from supply
(or Red)
Black wire from fixture
Ground wire from supply Ground wire from fixture
Post
Thank you for purchasing our product.
Need assistance with parts or assembly? Call our customer service or visit our website
Assembly Instruction