Operation Manual

10
• Fit the front grille (1), inserting the rear grille in the guide in the connecting
ring (6). You will hear a “click”. The fixing plate (7) must appear to be centred
in the lower section.
• Close the fixing plate (7) and tighten the safety screw.
USER INSTRUCTIONS
• Press the desired air speed switch to start the fan: low (12), medium(13) or
high (14).
• The fan will stop when the off switch (11) is pressed.
• To cause the fan to oscillate horizontally, press the button (11), to stop the
oscillation, gently pull the button up.
• The fan may also be inclined at an angle of 45º to the vertical. Adjust this
inclination pressing gently on the upper part of the motor shaft (8), forwards
or backwards. Fig. 4
• If the time-off timer (15) is not used when the fan is in operation, it must
stay in position I.
Turn-off timer
• This timer (15) allowed the time for which the fan is to remain in operation
to be set, up to a maximum of 2 hours. Turn the timer to select the desired
period of time, after which the fan will automatically switch off.
CLEANING AND MAINTENANCE
• Your appliance must be disconnected from the mains before any cleaning
operation is performed.
• Clean with a slightly damp cloth.
• Never immerse the appliance in water or any other liquid. Check that no
drops of liquid enter the motor area.
• Do not use solvents or abrasive cleaners to clean the device, since they could
damage its plastic parts.
• When the appliance is not in use it should be kept in a damp-proof loca-
tion.