olberg SMConfigurationA(Pg.3-10,11) Instruction Manual

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: [phone] Email: [e-mail] Web: www.solbergmfg.com
Page 13
*WARNING*
Failure to comply with these instructions
may result in system or equipment
contamination.
6. Securing Element.
A. Place new or cleaned element evenly in housing base. The wider end of
the element should be in line with the closing seam of the housing. See
figure C.6.1. Be sure the element seats properly in the housing base and
there is no dirt or particulate present on the sealing surfaces.
*WARNING*
Defective installation may cause system or
pump contamination. Use only genuine
Solberg replacement parts.
Figure C.6.1: Element in line with closing seam of housing.