Specification Sheet
Table Of Contents
456
CONSTRUCTION/SPECIFICATION CHECKLIST
• Generously sized throat and hood perimeter openings for low resistance and more efcient airow.
• Hood is constructed of .050" aluminum and assembled with standing seams and snap lock seams
that are secured with spot welds. No screws or rivets to break or work loose.
• Hood is reinforced and braced for extra rigidity and resistance to wind damage. Utilizes channels
and structural angles throughout.
• All hoods are fabricated with 1/2" x 1/2" mesh galvanized welded screen as standard equipment.
Screens are attached to full hood perimeter opening with stainless steel or zinc plated fasteners.
Screens are omitted when hoods are equipped with lters.
• Full 360° perimeter hood opening for total wind action from any direction for more reliable airow
performance.
• Curb base constructed of .080" aluminum. All corners are miter cut. All seams and corners are
continuous welded for strength and water tightness.
• Hoods have a special deector ange on edge of perimeter opening for added protection against
rain and snow. Wide overhang for storm protection.
MODEL OVERVIEW
Model BGH gravity ventilator offers a modern low silhouette design that blends with roof lines and
other equipment. Designed for maximum airow passage and weathertight integrity, Model BGH comes
in either intake or relief models in aluminum or galvanized nishes. An extensive range of sizes are
offered with many standard and optional features. Exhaust models have a 1:1 ratio of hood perimeter
opening to throat area and supply models incorporate a 2:1 ratio.
To meet other size or ventilation capacity requirements, in addition to those listed in the following tables,
custom sized units are available upon request. Consult your representative or factory for specic details
and performance capabilities.
Industry best 5 year fan housing warranty
GC_BGH_0111 January 2011
MODEL BGH
FABRICATED GRAVITY RELIEF/INTAKE VENTILATOR
MODEL FEATURES
• Exhaust or Supply air up to 90,000 CFM in static pressure applications
up to .25” w.g.
• Constructed of .050” aluminum
• Assembled with standing seams and snap-lock seams that are secured
with spot welds
• Modern, low silhouette design that blends roof lines and other equipment
All specications are subject to change without notice unless approved in submittal by Soler & Palau.