HM4-15E-01 Flat Panel Micathermic Heater w/ Electronic Controls 3092402 Model No. HM4-15E-01 © 2008 Soleus Air International www.sylvane.
Thank you for choosing a Soleus Air Micathermic heater. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new Soleus Air Micathermic heater. For your own records, please attach a copy of your sales receipt to this manual.
12. A heater has hot and arcing or sparking parts inside. DO NOT use in areas where gasoline, paint, explosive and/or flammable liquids are used or stored. Keep unit away from heated surfaces and open flames. 13. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No16.AWG minimum size and rated not less than 1500W. 14.
SAFETY FEATURES Tip-Over Safety Feature This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal switch will automatically shut the heater off. Once the heater is restored to an upright position, the heater will reset. To continue operation, turn on the heater using the control panel on the heater. Overheat Safety Feature This heater is equipped with a overheat safety feature.
PRODUCT DIAGRAM CARRY HANDLE DIGITAL DISPLAY CONTROL PANEL LEGS WHEELS 5 www.sylvane.
ASSEMBLY TOOLS NEEDED: Phillips Head Screwdriver 1. Remove the heater body, two wheelbases, wheels, screws, and washers from the box. Remove the packaging materials and keep for future storage. 2. Attach the wheels to each wheelbase with the supplied wheel screws, small black spring-washers, and small grey washers. Wheel Screw Wheel Small Black Spring-Washer Small Grey Washer Wheel Base 3. Be certain the heater is unplugged and the controls are set to off. Set the heater on the floor upside down. 4.
OPERATING INSTRUCTIONS CONTROL PANEL OPERATION 1. Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Only operate heater in upright position with caster wheels attached. 2. Turn the heater on by pressing the On/Off button on the control panel. 3. Select a heat setting: On the control panel, press the MODE button to toggle between the two heat settings; LOW (750W) and HIGH (1500W) . 4. Adjust the thermostat by pressing the arrows on the control panel.
OPERATING INSTRUCTIONS (CONTINUED) OPTIMAL OPERATING CONDITIONS To get the most out of your Soleus Air Micathermic heater, follow these helpful hints: 1. All electric heaters are limited to maximum of 1500 watts (per UL and ETL requirements). Due to this limitation all electric heaters can heat approximately 150 square feet. Micathermic heaters fit in this category, but they are able to provide a more comfortable and consistent heat than other heating technologies. 2.
MAINTENANCE 1. Unplug the unit and let it cool completely. 2. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater. 3. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater. 4. DO NOT immerse the heater in water. 5.
WARRANTY One Year Limited Warranty Soleus International Inc. warrants the accompanying Soleus Air heater to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of ONE (1) year from the date of original retail purchase in the United States. If the unit exhibits a defect in normal use, Soleus International Inc.
