16" Stand Fan with Remote Control Operating Instructions FS2-40R-32

5
OPERATING INSTRUCTIONS
Using Fan Controls
1. Set the fan on a stable, level surface.
2. Turn the fan on by pressing the POWER/SPEED button on the Control Panel or Remote Control.
3. Adjust the speed setting by pressing the POWER/SPEED on the Control Panel or remote control.
4. Pressing the MODE button on either the fan or the remote will choose the desired wind mode: Standard,
Sleep, & Natural. In standard mode the fan operates at a steady speed. In Sleep mode the fan decreases
speed in the middle of the oscillation pattern. Natural mode simulates the wind by randomly alternating the
fan speed.
5. To oscillate the fan head, press the OSCILLATION button located on the fan or the SWING button on the
remote. Each press of the oscillation button will change the oscillation pattern. You can choose between
side-to-side, up and down, and figure 8 oscillation patterns
6. This fan includes a 12 hour auto shut-off timer. To operate the timer, press the TIMER button (located on
the fan or on the remote) until the desired time is visible on the LCD Display. Each button press will
increase the time by 1 hour increments. Once the timer is set the you will see “HR” and a clock icon light
up on the display. Once set, the timer will count down to zero and turn off the fan.
7. To turn the fan off, press the POWER/SPEED button on the Control Panel or remote control until the unit
turns off.
Using the Auto-on Feature
1. First turn the fan on by pressing the POWER/SPEED button on the Control Panel or Remote Control. You
will see the current room temperature flashing on and off on the LCD display.
2. Once the fan is on, press the AUTO button located on the remote control or the control panel.
3. “AUTO” should now be displayed on the LCD display and the current room temperature will stop flashing
on the display. When the fan is in auto mode, it will vary speeds according to the room temperature. When
the room temperature is below 68° the fan will be in standby mode (off). When the temperature is between
68° F and 74° F the fan will operate at low speed (1). When the temperature is between 75° F and 81° F the
speed will increase to medium (2). The fan will operate at high speed (3) once the room temperature is
equal to or greater than 82° F.
Adjusting Height and Fan Head Tilt
1. To adjust the height of the fan, turn the Adjustable Height Knob (L) counter-clockwise to loosen the
stand. Adjust the fan to the desired height, then firmly tighten to secure into place.
2. To adjust the tilt on the Fan Head, loosen the knob below the Motor Housing and tilt the fan
forward/back by pulling or pushing the top of the Fan Grill. The fan will make a clicking noise while
being adjusted. Once the Fan Head is set to the desired tilt, tighten the knob to secure into place.