HGW-308R-W Wall Mountable Micathermic Heater w/ Remote 3092402 Model No.
Thank you for choosing a Soleus Air Micathermic heater. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new Soleus Air Micathermic heater. For your own records, please attach a copy of your sales receipt to this manual.
12. A heater has hot and arcing or sparking parts inside. DO NOT use in areas where gasoline, paint, explosive and/or flammble liquids are used or stored. Keep unit away from heated surfaces and open flames. 13. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No16.AWG minimum size and rated not less than 1500W. 14.
SAFETY FEATURES Tip-Over Safety Feature This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal switch will automatically shut the heater off. Once the heater is restored to an upright position, the heater will reset. To continue operation, turn on the heater using the supplied remote control or the control panel on the heater. Overheat Safety Feature This heater is equipped with a overheat safety feature.
PRODUCT DIAGRAM CARRY HANDLE & WALL MOUNT (on back) DIGITAL DISPLAY CONTROL PANEL LEGS WHEELS 5
ASSEMBLY - REMOVING THE HEATER FROM THE PACKAGING Remove the heater from the box. NOTE: Product drawings may slightly differ from actual product. Assembly and packaging are the same as depicted in the drawings Remove the Styrofoam from both ends of the heater, and remove the plastic bag. Remove the 2 remaining bags from the box.. One bag contains: feet with casters. [Fig 1] The other bag contains: 1 mounting support, 4 screws and 4 drywall anchors for wall mounting.
ASSEMBLY - INSTALLATION Required Tools for Floor Use: Phillips screwdriver (not supplied) Estimated Assembly Time for Floor Use: 1 minute Assembly Instructions for Floor Use: Insert the feet and bolts onto the unit as shown in the diagram. Required Tools for Wall Mounting: Phillips screwdriver (not supplied) Drill (not supplied) Hammer (not supplied) Estimated Mounting Time: 5 minutes Mounting Instructions: STEP 1 Using the mounting support as a guide, mark the first screw hole on the wall.
OPERATING INSTRUCTIONS CONTROL PANEL & REMOTE OPERATION 1. Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Only operate heater in upright position with caster wheels attached. 2. Turn the heater on by pressing the On/Off button on the control panel or the supplied remote control. 3. Select a heat setting: On the control panel, press the MODE button to toggle between the two heat settings; LOW (1000W) or HIGH (1500W) .
OPERATING INSTRUCTIONS (CONTINUED) OPTIMAL OPERATING CONDITIONS To get the most out of your Soleus Air Micathermic heater, follow these helpful hints: 1. All electric heaters are limited to maximum of 1500 watts (per UL and ETL requirements). Due to this limitation all electric heaters can heat approximately 150 square feet. Micathermic heaters fit in this category, but they are able to provide a more comfortable and consistent heat than other heating technologies. 2.
MAINTENANCE 1. Unplug the unit and let it cool completely. 2. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater. 3. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater. 4. DO NOT immerse the heater in water. 5.
WARRANTY One Year Limited Warranty Soleus International Inc. warrants the accompanying Soleus Air heater to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of ONE (1) year from the date of original retail purchase in the United States. If the unit exhibits a defect in normal use, Soleus International Inc.
