Owner's manual
YOU WILL SEE
:
TO OPERATE ON FAN ONLY:
DO THIS:
PRESS
MODE BUTTON
CHOOSE
FAN ONL
Y
LIGHT ON
Note: Use this function only when cooling is not desired but room air circulation is needed. You can choose any fan speed you prefer,
EXCEPT AUTO FAN. During this function, the display will show the current room temperature, not the set temperature.
TO USE THE
ENERGY SAVER FEATURE:
LIGHT ON
YOU WILL SEE
:
DO THIS:
PRESS
MODE BUTTO
N
CHOOSE
ENERGY SAVE
R
TIMER-DELAY YOU WILL SEE
FIRST DO THIS:
PRESS TIMER BUTTON
THEN
DO THIS:
PRESS TEMP/TIMER
BUTTON
THE TIME CHOSEN:
START/STOP FEATURE:
LIGHT ON
Note 1: For Auto Off, the unit must be in the ON position.
Note 2: For Auto On, the unit must be in the OFF position.
Note: In this mode, the fan will continue to run for a short time after the compressor cycles off.
To adjust timer setting, tap or hold the UP arrow (^) or DOWN arrow (v) to change the delay time by 0.5 hour increments up to 10 hours,
then by 1 hour increments up to 24 hours. The unit will count down the time remaining until start (8, 7.5, 7, etc.). After
setting the Timer, the unit will enter into Timer mode after 5 seconds, and the Timer light will turn on. In Timer mode:
The set temp and fan speeds
will be saved; The LED displays the set temperature, not the current room temperature.
Press the Timer once, and the LED will display remaining time of set time, LED return to set temperature by 5 seconds;
When in Fan Only mode, LED will display the room temperature, not display set temperature.Turning the unit "ON" or
"OFF" will cancel the Auto ON/OFF function. The Auto ON/OFF feature will work until the unit either starts
or stops. Once this happens the timer will need to be reset.
COOLING FEATURE
(on some models)
:
YOU WILL SEE
DO THIS:
:
PRESS
MODE BUTTO
N
SELECT COOL
Note:This feature can be used with any combination of FAN Speeds, Timer, or Sleep Modes. When in the “Cool” Mode, the fan will
run continuously when cooling is needed. The temperature will automatically be maintained anywhere between 61°F (16°C) and 86°F
(30°C). When the set room temperature is reached, the fan will cycle off and on to circulate and sample the room air. If the air conditioner
is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately 3 minutes
for the compressor to start and cooling to begin.
Air Conditioner Features
(continued)
11