User Manual

MODEL SBB500ss-v3
OPERATION INSTRUCTIONS
Features
1)
2) Alarm 1 Indicator
3) PM Indicator
4) Snooze button /
Snooze Time
Adjustment/
Dimmer Control
5) Volume Wheel
6)
Alarm Set / Alarm
Duration
Adjustment
7)
Time Set Button
8)
Alarm Off Button
9)
Alarm Function
Switch
10) Fast Min./ Hour
Button / 12 or
24 Hour
Selector
11)
Slow Min./
Hour Button
12) Battery
Compart
ment
13) Alarm Mode
Switch
14) DC Adaptor
Input
15) Tone Control
Wheel
16) Vibrator Output
17) Flashing Light
Display
18) Alarm 2
Indicator
Test Mode:
1) Press and hold the Snooze and Time buttons for 3 seconds to enter the Test
Mode. The display will show "7ES7" to indicate it is in TEST Mode.
2) If within 1 minute no button is pressed, then it will exit the Test Mode and return
back to the Time Mode.
3) Press any button within 1 minute (except the Snooze & Time buttons, which has no
effect), it will exit the Test Mode immediately.
4) While in Test Mode, sliding the Function Switch will demonstrate the different
functions of the clock:
a) Function Switch at OFF, it will have a continuous "Vee" sound to indicate it is in
the Test Mode.
b) Function Switch at BUZZ, it will demonstrate the buzzer sound.
c) Function Switch at VIB, it will demonstrate the vibrator.
d) Function Switch at VIB & BUZZ, it will demonstrate the buzzer sound & the
vibrator.
5) After finish with the Test Mode, press any button (except the Snooze & Time
buttons, which has no effect) it will exit the Test Mode immediately.
Setting the Correct Time –
1) Press and hold the “TIME“ Button (6) and at the same time press the
“FAST“ Button (9) or the “SLOW“ button (10) to advance clock display unil you
have desired time.
2) The lighted dot (2) located in upper left corner of the clock display indicates the
time is PM. For AM time, this dot will not light up.
Setting the Alarm Time–
Setting Alarm 1
1) Slide the “ALARM MODE SWITCH“ (12) to AL1 position, the alarm indicator
“AL1“ (1) will light up.
2) Press and hold the “ALARM SET“ (5) button and at the same time press the
“FAST“ Button (9) or the “SLOW“ button (10) to advance clock display until you
reach desired alarm setting.
3) Make sure alarm time is correctly set for AM or PM (1).