User's Manual

Page 26
Create access to the LAN for NetExtender:
1. In the Firewall > Access Rules page, click .
2. In the Welcome to the SonicWALL Network Access Rules page, click Next.
3. In the Step 1: Access Rule Type page, select General Rule. Click Next.
4. In the Step 2: Access Rule Service page, select Any. Click Next.
5. In the Step 3: Access Rule Action page, configure:
Click Next.
6. In the Step 4: Access Rule Source Interface and Address page, perform the
following selections and then click Next:
7. In the Step 5: Access Rule Destination Interface and Address page, perform the
following selections and then click Next:
8. In the Step 6: Access Rule Time page, leave Time Active set to Always Active
unless you want to limit when you want SSL-VPN clients to have access to the LAN.
9. In the Congratulations page, click Apply to create the access rule.
Continue to Step
Select Action for this
Rule
Allow
TCP Connection
Inactivity TImeout
30 minutes
Interface DMZ
IP Address Begin The beginning of the NetExtender range, default,
192.168.200.100
IP Address End The end of the NetExtender range, default, 192.168.200.200
Interface LAN
IP Address Begin *
IP Address End Leave blank