Installation Sheet

ManualsBrandsSonneman ManualsChandeliersSonneman Double Corona 31-1/2" Wide Integrated LED Ring Chandelier with Acrylic Shades

2 of 2

December 28, 2017

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Double Corona Series - 24" LED Pendant, 32" LED Pendant

Important

• Always disconnect the power before installing and before cleaning or other maintenance.

• Consult a qualiﬁed, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualiﬁé pour vous assurer que les conducteurs de la dérivation sont adéquats.

1. Shut off power to the outlet box (A).

2. Determine the height at which the xture (B) is to be hung. Adjust

the steel cable (C) to the desired height. To shorten the cable, push

the cable up and it will be locked automatically. To lengthen the cable,

lift up on the cable and push up on the lock (D). While keeping the

lock depressed, lower the cable to the desired length. Release the lock

to set.

3. Use the screwdriver to loosen the set screw (E). Adjust the

power cords (F) to the desired length. Tighten the set screw to set.

Reserve extra cord in the canopy (G).

4. Attach mounting plate (H) to the outlet box (A), secure with

outlet box screws (J).

5. Make appropriate electrical connections using wire nuts:

a. Connect the LED drivers' (K) live wires (black) to the live outlet box

wire.

b. Connect the LED drivers' neutral wires (white) to the neutral outlet

box wire.

c. Connect the xture’s (B) ground wire (green or uncoated) to the

ground outlet box wire. If no ground is present in outlet box, connect

xture’s ground wire to the mounting plate (H) using the green screw

(included).

d. Carefully place connections in canopy (G).

6. Install canopy (G) to mounting plate (H), secure with

canopy screws (L).

7. Adjust steel cable (C) and power cords (F) to level the xture (B) if

necessary.

8. Slide the cable guide (M) to desired position by using the slotted

screwdriver to loosen the set screws (N). Tighten set screws to set.

Warning: The angle of the cables must be less than 45 degrees from

vertical.

9. Restore power to the outlet box (A).

Note

• This ﬁxture is dimmable with Electronic Low Voltage (Trailing-Edge), Incandescent (Leading-Edge), and 0-10V type

dimmers only.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the ﬁnish, avoid any harsh abrasives or chemicals.

2303, 2303-J20, 2305, 2305-J20

2305, 2305-J20

2303, 2303-J20