Installation Sheet

ManualsBrandsSonneman ManualsChandeliersDouble Corona 48" Wide Integrated LED Ring Chandelier with Acrylic Shades

2 of 2

December 28, 2017

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Double Corona Series - 48" LED Pendant, 60" LED Pendant

Important

• Always disconnect the power before installing and before cleaning or other maintenance.

• Consult a qualiﬁed, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualiﬁé pour vous assurer que les conducteurs de la dérivation sont adéquats.

1. Shut off power to the outlet box (A).

2. Determine the height at which the xture (B) is to be hung. Adjust

the steel cables (C) to the desired height. To shorten the cable, push

the cable up and it will be locked automatically. To lengthen the

cable, lift up on the cable and push up on the lock (D). While keeping

the lock depressed, lower the cable to the desired length. Release the

lock to set.

3. Use the screwdriver to loosen the slotted set screw (E). Adjust the

power cords (F) to remove most of the slack. Tighten the set screw to

set. Reserve extra cord in the canopy (G).

4. Loosen the screws on the safety cable coupling (H) and undo the

loop. Pass the safety cable through a hole on the cross bar (J) and

insert the end back through the coupling to form a loop. Tighten the

coupling screws to secure the safety cable.

5. Screw the threaded nipple (K) through the nut (L) on the cross bar (J),

secure cross bar with outlet box screws (M).

6. Make appropriate electrical connections using wire nuts:

a. Connect the LED drivers' (N) live wires (black) to the live outlet box

wire.

b. Connect the LED drivers' neutral wires (white) to the neutral outlet

box wire.

c. Connect the xture’s ground wire (green or uncoated) to

the ground outlet box wire. If no ground is present in outlet box,

connect xture’s ground wire to the cross bar (J) using the green

screw (included).

d. Carefully place connections and LED driver in canopy (G).

7. Install canopy (G) by screwing nial (P) on the threaded nipple (K).

8. Level the xture (B) by adjusting the steel cables (C) only,

then remove slack from the power cords (F).

Warning: Fixture weight must be supported by the steel cables,

not by the power cords.

9. Slide the cable guide (Q) to desired position by using

the slotted screwdriver to loosen the set screws (R).

Tighten set screws to set. Warning: The angle of

the cables must be less than 45 degrees from vertical.

10. Restore power to the outlet box (A).

Note

• This ﬁxture is dimmable with Electronic Low Voltage (Trailing-Edge), Incandescent (Leading-Edge), and 0-10V type

dimmers only.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the ﬁnish, avoid any harsh abrasives or chemicals.

2307, 2307-J20, 2309, 2309-J20

2309, 2309-J20

2307, 2307-J20