Component Video Switcher Installation Manual

SONY CAV-CVS12ES (US) 3-198-136-11(1)
7
US
Getting Started
Rear panel of the Component Video Switcher
~ AC IN
SOURCE 12
OUTIN
S12
ASSIGNABLE
SOURCE 11
OUTIN
S11
ASSIGNABLE
SOURCE 10
OUTIN
S10
ASSIGNABLE
SOURCE 9
OUTIN
S9
ASSIGNABLE
SOURCE 8
OUTIN
SOURCE 7
OUTIN
SOURCE 6
OUTIN
SOURCE 5
OUTIN
SOURCE 2
OUTIN
SOURCE 1
OUTIN
Y
PB
PR
SOURCE 4
OUTIN
SOURCE 3
OUTIN
ZONE 3
VIDEO OUT
ZONE 2
VIDEO OUT
ZONE 1
VIDEO OUT
ZONE 4
VIDEO OUT
ZONE 5
VIDEO OUT
ZONE 6
VIDEO OUT
ZONE 7
VIDEO OUT
ZONE 8
VIDEO OUT
ZONE 9
VIDEO OUT
ZONE 10
VIDEO OUT
ZONE 11
VIDEO OUT
ZONE 12
VIDEO OUT
IR REMOTE
IN
RS-232C
CAVAUX
 SOURCE 1 ~ 8 connection jacks
a) VIDEO IN
An RCA jack for component video input from a source
component.
b) VIDEO OUT
An RCA jack for connecting a video source to another local
component.
Note
The video loop-through output is not active when the Main Unit is
turned off.
 SOURCE 9 ~ 12 connection jacks
a) VIDEO IN
An RCA jack for composite video input from a source
component.
b) VIDEO OUT
An RCA jack for connecting a video source to another local
component. The composite video signal is up-converted to
the component video signal automatically.
Note
The video loop-through output is not active when the Main Unit is
turned off.
 ASSIGNABLE switch for SOURCE 9 ~ 12
Assign the source component connected to source 9 ~ 12 to
source 1 ~ 8. For example, when the SOURCE 9
ASSIGNABLE switch is set to “1”, the source 9 video signal is
distributed to the zone selected for source 1.
Notes

Set the ASSIGNABLE switch to “0” when you do not use the
assign function.

When you assign two or more source components to the same
source number, the assigned source numbers of SOURCE
indicator blink as an error indication.
 AC IN
Connects the supplied AC power cord to AC IN.
 ZONE VIDEO OUT
A CAT5 RJ45 connector that sends a source video signal to
the component video input of a zone. Use a CAT5 cable for
the connection.
 IR REMOTE IN
A 3.5 mm monaural mini jack for receiving the SIRCS code
from the connected IR-controlled component. The Main
Unit can be equally controlled by the RS-232C commands.
Note
The remote control is not supplied.
 RS-232C
a) AUX
Connects to other RS-232C components, allowing the Main
Unit to be controlled by other RS-232C components. Use an
RS-232C cross cable for the connection.
b) CAV
Connects to the CAV-M1000ES, allowing the Main Unit to
be controlled by the CAV-M1000ES. Use an RS-232C cross
cable for the connection.