User's Manual

12.Important Notice for Radio Regulations

Antenna

This module has the approval of the module certification with below antenna:

FPC-ANT-B (Sony P/N 1-981-353-11, Peak Gain -1.40dBi, Cable Length 34mm)

FCC Information

Since this module is not sold to general end users directly, there is no user manual of

module.

For the details about this module, please refer to the specification sheet of module.

This module should be installed in the host device according to the interface

specification (installation procedure).

This module complies with Part 15 of the FCC rules.

- FCC ID: AK8FLN01WBM

When using this “FL-N01-WBM” module as radio device in US market device, installer

must keep below condition.

1) The label that attached back side of the module indicates complied ID.

DO NOT remove that label or put another label on this indication label.

2) If the FCC ID is not visible when the module is installed inside host device, then

the outside of the host device into which the module is installed must also display

a label referring to the enclosed module. In that case, the final end product must

be labeled in a visible area with the following:

&RQWDLQV)&&,'$.)/1:%0

About indication: It is required that easily readable font size, but not required to

keep more than 8 point. Line feed in middle of sentence is not acceptable.

3) Need to indicate below sentence on the final product label.

7KLVGHYLFHFRPSOLHVZLWKSDUWRIWKH)&&5XOHV2SHUDWLRQLVVXEMHFWWRWKH

IROORZLQJWZRFRQGLWLRQV7KLVGHYLFHPD\QRWFDXVHKDUPIXOLQWHUIHUHQFH

DQG  WKLV GHYLFH PXVW DFFHSW DQ\ LQWHUIHUHQFH UHFHLYHG LQFOXGLQJ

LQWHUIHUHQFHWKDWPD\FDXVHXQGHVLUHGRSHUDWLRQ

PAGE 1
2. Important Notice for Radio Regulations Antenna This module has the approval of the module certification with below antenna: FPC-ANT-B (Sony P/N 1-981-353-11, Peak Gain -1.40dBi, Cable Length 34mm) FCC Information Since this module is not sold to general end users directly, there is no user manual of module. For the details about this module, please refer to the specification sheet of module.
PAGE 2
Basically above indication is required to label on final end product. But when that final end product is small case, it is approved that only indicate in the final end product user’s manual. ** That condition example of small product is smaller than 8 cm x 10cm or smaller than the hand. But there is a different opinion by verifier of the FCC and the TCB. So it is recommended that installer check in advance. 4) Need to indicate below sentence on the final product manual.